using:ffv1rec
Differences
This shows you the differences between two versions of the page.
| Both sides previous revision Previous revision Next revision | Previous revision Next revision Both sides next revision | ||
|
using:ffv1rec [2010/04/15 15:52] j.m |
using:ffv1rec [2010/04/15 15:54] j.m |
||
|---|---|---|---|
| Line 10: | Line 10: | ||
| * Using AVI: could use other codecs but there would be sync problems | * Using AVI: could use other codecs but there would be sync problems | ||
| - | The original code was modified from the [[http://fixounet.free.fr/gatos/|Nuppel GATOS]] to encode video using the [[http://en.wikipedia.org/wiki/Xvid|Xvid]] codec in interlaced mode. Since then, it has gone through changes, a lot of problems and re-writing, and help from the from [[http://www.ffmpeg.org/|FFmpeg]] project. | + | The original code was modified from the [[http://fixounet.free.fr/gatos/|Nuppel GATOS]] to encode video using the [[http://en.wikipedia.org/wiki/Xvid|Xvid]] codec in interlaced mode. Since then, it has gone through changes, a lot of problems and re-writing, and help from the [[http://www.ffmpeg.org/|FFmpeg]] project. |
| ===== Main differences to nuppelrec ===== | ===== Main differences to nuppelrec ===== | ||
| Line 17: | Line 17: | ||
| * You can specify audio frequency, like 48000 for DVD conversion later using the **-b** switch. | * You can specify audio frequency, like 48000 for DVD conversion later using the **-b** switch. | ||
| * You can store your settings in $HOME/.ffv1recrc (Configuration & Settings section). | * You can store your settings in $HOME/.ffv1recrc (Configuration & Settings section). | ||
| - | * You can select the video codec using the **-C** switch. Recommended: XviD or [[http://en.wikipedia.org/wiki/HuffYUV|HuffYUV]]. | + | * You can select the video codec using the **-C** switch. Recommended: Xvid or [[http://en.wikipedia.org/wiki/HuffYUV|HuffYUV]]. |
| * You can select the motion search using the **-M** x switch. Recommended: 0 or 1. | * You can select the motion search using the **-M** x switch. Recommended: 0 or 1. | ||
| * You can select the quantizer using the **-q** x switch. Recommended: 5. | * You can select the quantizer using the **-q** x switch. Recommended: 5. | ||
using/ffv1rec.txt ยท Last modified: 2012/11/11 08:51 (external edit)
Page Tools
Except where otherwise noted, content on this wiki is licensed under the following license: CC Attribution-Share Alike 4.0 International
